web analytics
Home  >  Blog  >  Amine Ethoxylates in Agrochemical Adjuvants: Boosting Spray Coverage and Leaf Uptake

Amine Ethoxylates in Agrochemical Adjuvants: Boosting Spray Coverage and Leaf Uptake

Amine Ethoxylates in Agrochemical Adjuvants Boosting Spray Coverage and Leaf Uptake

Direct answer

Amine ethoxylates are surfactants made by adding ethylene oxide to fatty amines such as tallow, coco or oleyl amine. In agrochemical adjuvants they lower the surface tension of spray droplets, improve spreading and retention on waxy leaves, and can increase active ingredient penetration through the plant cuticle. Performance depends on the fatty chain, the number of ethylene oxide units, and the formulation.

Key takeaways

  • The fatty amine chain and EO number decide whether the surfactant behaves as an oil-soluble, cationic-leaning wetter or a water-soluble, non-ionic-leaning spreader.
  • Lower surface tension and contact angle help droplets cover hard-to-wet waxy foliage instead of beading and running off.
  • Surfactants can aid uptake by solubilising cuticular waxes and slowing droplet drying, but the effect depends on the active ingredient, crop and weather.
  • Regulation is moving: the European Union prohibits POE-tallowamine in glyphosate-containing products under Commission Regulation (EU) 2016/1313, and aquatic toxicity remains a central review point.
  • Selection should rest on EO number, amine value, cloud point, compatibility with the active salt and crop phytotoxicity trials, not on the product name alone.

Why do spray droplets bead up and run off waxy leaves?

Droplets bead up because the leaf surface is waxy and the spray liquid is mostly water. Water has a surface tension of about 72 mN/m at 25 °C, so on a hydrophobic cuticle it forms near-spherical drops with a high contact angle. Those drops bounce, roll or run off instead of spreading.

Three leaf traits make the problem worse:

  • Epicuticular wax: Crystalline wax layers, often thick on cereals, grasses and brassicas, repel water.
  • Hairs and surface roughness: Trichomes and micro-ridges trap air under a droplet and hold it away from the cuticle.
  • Leaf angle: Upright, narrow leaves give a droplet very little to rest on.

A beaded drop wets a small area, dries as a concentrated spot and leaves the active ingredient with only a small contact patch to enter through. That is the gap a surfactant is added to close, and amine ethoxylates are one long-established class used for it.

What is an amine ethoxylate, and where does it sit among adjuvants?

An amine ethoxylate is a surfactant made by reacting a fatty amine with ethylene oxide, so that polyoxyethylene chains attach to the nitrogen atom. An agrochemical adjuvant is any substance added to a formulation or spray tank to improve how the active ingredient is applied or how well it works.

Weed-science literature commonly splits adjuvants into two groups:

  • Activator adjuvants, such as surfactants and oils, which change how the spray wets, penetrates or is absorbed by the plant.
  • Utility adjuvants, such as buffers, water conditioners, antifoams and drift-control agents, which change how the spray solution itself behaves.

Amine ethoxylates are activator adjuvants. Their fatty chain comes from sources such as tallow (mainly C16 to C18), coconut (mainly C12 to C14), oleic or soya oils. The ethoxylation degree, called the EO number, commonly runs from about 2 to 20 units.

Amine ethoxylates also carry a charge that depends on conditions. The nitrogen can pick up a proton in acidic solution, so low-EO grades lean cationic, while high-EO grades behave more like non-ionic surfactants.

What happens to a spray droplet between the nozzle and the leaf cuticle?

A surfactant acts at five points in the life of a droplet, and each can be tested on its own. Surfactant solutions commonly lower surface tension from about 72 mN/m to roughly 30 to 40 mN/m, depending on type and concentration.

  1. Impact. Lower dynamic surface tension helps a droplet stay on the leaf on impact instead of bouncing or shattering off.
  2. Spreading. The contact angle falls, so the droplet flattens over a larger area of cuticle.
  3. Retention. Every leaf has a point of run-off, beyond which extra spray volume drips away. Good wetting lets more of the dose stay below that point.
  4. Drying. Some surfactant deposits stay moist longer, which keeps the active ingredient in solution and available for uptake.
  5. Penetration. Surfactant molecules can interact with cuticular wax and ease diffusion of the active across it. At high concentrations they can also disturb plant cell membranes, which may aid movement but is also the source of leaf burn.

The benefit is largest for water-soluble actives that otherwise cross a lipophilic cuticle slowly. It depends on species, leaf age, humidity, temperature and the interval before rain, so glasshouse or field data on the specific formulation should confirm it. Surfactants also change droplet size, so drift needs to be checked with the chosen nozzle.

Low, medium or high EO: which range does which job?

A lower EO number gives a more oil-soluble surfactant with stronger penetration and higher crop and aquatic risk, and a higher EO number gives a more water-soluble, generally milder one. The ranges below are approximate and shift with the fatty amine and the supplier.

  • Low EO (about 2 to 8): Oil-soluble to dispersible, cationic-leaning in acid. These grades give fast wetting and strong penetration and often act as emulsifier or coupling components in concentrates. They carry the highest risk of leaf burn and toxicity to aquatic life.
  • Medium EO (about 8 to 15): A middle ground in solubility and wetting speed. Many general-purpose adjuvant systems sit here, and crop safety margins are wider than at the low end.
  • High EO (about 15 and above): Water-soluble and closer to non-ionic in behaviour. They tolerate electrolytes better and are milder on crops, but wet and penetrate more slowly.

Hydrophilic-lipophilic balance (HLB) moves in the same direction as EO number, so it is a quick screening value. It does not replace a trial on the target crop.

The glyphosate case: how one regulation reshaped adjuvant choice

Glyphosate is the clearest example of amine ethoxylates at work, and of how regulation can change a formulation. It is a water-soluble herbicide supplied as salts, such as isopropylamine or potassium salt, which are highly polar and cross the waxy cuticle slowly. Concentrates have therefore long included a surfactant.

Polyoxyethylene tallow amine (POE-tallowamine, CAS 61791-26-2, also written POEA) was widely used for that role. Commission Implementing Regulation (EU) 2016/1313 prohibits it as a co-formulant in glyphosate-containing plant protection products in the European Union.

Formulators in restricted markets moved to other surfactant types, including alkyl polyglucosides, fatty alcohol ethoxylates and ethoxylated ether amines. Amine ethoxylates remain in use in other markets and in other roles:

  • Foliar herbicides and plant growth regulators built on water-soluble actives
  • Foliar fertiliser and micronutrient sprays that must wet waxy leaves
  • Stand-alone tank-mix adjuvants sold separately from the pesticide

The tank matters as well. Hard water and high electrolyte loads can reduce surfactant performance, which is why conditioners such as ammonium sulfate are sometimes added to glyphosate sprays.

Four spray problems and how an amine ethoxylate adjuvant is chosen for each

Selection works best when it starts from the failure being fixed, not from the product name. Each problem below points to a different grade and a different test.

  • Droplets bead on grasses or waxy broadleaves. Look at wetting speed and contact angle. A lower-EO grade wets faster, but needs a crop-safety trial.
  • Rain is forecast soon after spraying. Look at how quickly the active is absorbed. Faster penetration can help, but the rain-free period depends on the active ingredient, so follow the label.
  • The spray water is hard or salty. Look at electrolyte tolerance and cloud point. Dissolved calcium and magnesium can reduce the performance of some actives, and a water conditioner may be needed.
  • The crop shows leaf burn. Look at dose and EO number. A higher-EO grade or a lower rate is the usual first step, always confirmed in a trial.

Specification checks that support those decisions:

  1. Fatty chain: Tallow gives a more lipophilic surfactant than coco.
  2. EO number and HLB: Both control water solubility and wetting speed.
  3. Amine value: Measured, for example, by ASTM D2074, it indicates free amine content and basicity, which affects compatibility with acidic actives.
  4. Gel behaviour: Amine ethoxylates can pass through gel phases on dilution, so test pourability and dilution of the concentrate.
  5. Surface tension at use dilution: Compare solutions with a standard method such as OECD Test Guideline 115.
  6. Environmental data: Request aquatic toxicity data for the exact grade.

What regulatory, toxicity and environmental rules apply to amine ethoxylates?

Amine ethoxylates face closer scrutiny than many adjuvants because of aquatic toxicity and, for POE-tallowamine, concerns raised during glyphosate reviews. Rules differ by region and by whether the surfactant is a co-formulant or a stand-alone adjuvant.

European Union

Plant protection products fall under Regulation (EC) No 1107/2009, and Implementing Regulation (EU) 2016/1313 prohibits POE-tallowamine in glyphosate products. Chemicals placed on the market also need REACH registration.

United States

The Environmental Protection Agency regulates inert ingredients in pesticide formulations, with tolerance exemptions listed in 40 CFR 180.910 and 180.920. Stand-alone adjuvants are generally handled through state registration and label rules, which vary.

India and other markets

Treatment of adjuvants varies. In India, pesticide formulations are governed by the Insecticides Act, 1968, and some jurisdictions register adjuvants as products while others do not, so the local regulator’s position should be checked.

Environment and worker safety

Cationic and amine-based surfactants are typically more toxic to fish, aquatic invertebrates and algae than many non-ionic alternatives, so labels often require buffer zones near water. Higher-EO grades are generally less toxic than low-EO grades, but data should be requested for the exact product. Fatty amine ethoxylates can irritate skin and eyes and are alkaline in solution, so SDS-based handling with gloves and eye protection applies.

Common mistakes and things to check before buying or specifying

Most adjuvant failures come from mismatched chemistry or missing data. Each mistake below is paired with the check that prevents it, whether the question is about an amine ethoxylates manufacturer, supplier or exporter.

  1. Specifying by fatty amine name only. Define the fatty source, EO number, amine value, water content and the pH of a stated dilution.
  2. Assuming more surfactant is better. Excess can cause run-off, leaf burn and drift changes, so test dose rates on the actual crop.
  3. Overlooking regional restrictions. A grade acceptable in one country may be banned in another, as POE-tallowamine is in glyphosate products in the EU. Check the destination market first.
  4. Ignoring water quality. Hard water and electrolytes can cause cloudiness, separation or reduced efficacy. Test with the real spray water.
  5. Skipping gel and low-temperature checks. Concentrates can gel on dilution or thicken in cold storage, so test pourability and dilution.
  6. Not asking for aquatic toxicity data. Environmental review is often the limiting step, so request data for the exact grade.
  7. Confusing look-alikes. Ether amine ethoxylates, quaternary amine ethoxylates and alcohol ethoxylates are different chemistries with different safety profiles.
  8. Relying on one batch. Request a certificate of analysis for each lot and compare EO distribution and free amine over time.
  9. Leaving out documentation and logistics. Request the safety data sheet, technical data sheet, regulatory statements, packaging options and lead time before a bulk order.

    Conclusion: what to decide next

    Amine ethoxylates can improve spray coverage and leaf uptake, but the benefit depends on the fatty chain, the EO number and the active ingredient, and it must be balanced against crop safety, aquatic toxicity and regional rules. Define the target crop, active ingredient and market first, then shortlist grades by EO number, amine value, cloud point and compatibility.

    If you are evaluating amine ethoxylates for a specific adjuvant application, request a technical data sheet, compliance documents and sample specifications from your shortlisted manufacturers and suppliers before finalizing.

What do amine ethoxylates do in agrochemical adjuvants?

They act as wetting, spreading and penetration aids. By lowering the surface tension of spray droplets they improve coverage on waxy leaves, and they can help active ingredients cross the cuticle. In some formulations they also serve as emulsifier or coupling components alongside other surfactants.

Why is POE-tallowamine prohibited in EU glyphosate products?

Commission Implementing Regulation (EU) 2016/1313 prohibits POE-tallowamine as a co-formulant in glyphosate-containing plant protection products, following an assessment that raised concerns about its toxicity profile. The regulation text and the underlying assessments give the details, and EU formulators have moved to alternative surfactants.

Which EO number is best for a foliar herbicide?

There is no single value. Lower EO numbers, roughly 2 to 8, tend to give stronger penetration but more crop risk, while numbers of about 15 and above are more water-soluble and typically milder. The choice depends on the active ingredient, crop and formulation, and needs phytotoxicity trials.

How much adjuvant should be added to a spray tank?

Rates vary by product, active ingredient and crop, and the pesticide label governs permitted use. Tank-mix surfactants are commonly applied at roughly 0.1% to 0.5% volume per volume of spray solution, but the product label or local extension guidance should always be followed.

How do amine ethoxylates compare with alcohol ethoxylates as adjuvants?

Amine ethoxylates lean cationic at low EO and can penetrate waxy cuticles more strongly, but they are typically more toxic to aquatic life. Alcohol ethoxylates are non-ionic, generally milder and widely used where lower toxicity or broader compatibility is needed. The choice depends on the active ingredient and on regulation.

Can an amine ethoxylate increase spray drift?

It can change it in either direction. Surfactants alter droplet formation, and drift depends on droplet size spectrum, nozzle type, pressure and wind. Some adjuvants increase droplet size and reduce fine droplets, while others do the opposite. Test drift with the actual nozzle and formulation, and follow local drift rules.

How should a buyer evaluate an amine ethoxylates manufacturer or supplier?

Request the technical data sheet, safety data sheet and a certificate of analysis showing amine value, water content and pH with named methods. Ask for aquatic toxicity and regulatory status in the target market, compare batch consistency, packaging and lead time, and run a sample trial on the target crop and tank mix.

wordpress theme by jazzsurf.com